Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Audi A8Oil Type & Capacity
OEM spec from the factory service manual for the Base, 3.0L Eng VIN G variant.
Quick Answer
Oil Type
SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043.
Capacity (w/ Filter)
7.19 QTS.
6.8 L
Variant
Base, 3.0L Eng VIN G
Note: Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty.
DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty.
Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger.
Quantities are approximate.
DO NOT overfill.
Source: Factory service manual — 2013 Audi A8 Base, 3.0L Eng VIN G. View full manual section →
What You'll Need
Engine Oil
SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043. for Audi A8
Search Amazon →
Oil Filter
Audi A8 Oil Filter
Search Amazon →
Tool
Oil Filter Wrench
Search Amazon →
Kit
Funnel + Drain Pan Kit
Search Amazon →
Frequently Asked Questions
- What type of oil does a 2013 Audi A8 take?
- The 2013 Audi A8 requires SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043.. The exact spec may vary slightly by engine variant — this page shows the OEM recommendation for the Base, 3.0L Eng VIN G configuration.
- How much oil does a 2013 Audi A8 need?
- The 2013 Audi A8 takes 7.19 QTS. (6.8 L) of engine oil with the filter replaced.
- Can I use synthetic oil in my 2013 Audi A8?
- Yes — synthetic oil that meets the SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043. specification is acceptable and often preferred for better protection and longer change intervals.
- What happens if I use the wrong oil in my 2013 Audi A8?
- Using oil that does not meet the SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 2010043. specification can reduce engine protection, increase wear, and potentially void warranty coverage. Always use oil that meets the OEM spec.