What type of oil does a 2008 Audi S4 take?

The 2008 Audi S4 requires SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855).. The exact spec may vary slightly by engine variant — this page shows the OEM recommendation for the Avant Quattro, Automatic configuration.

How much oil does a 2008 Audi S4 need?

The 2008 Audi S4 takes 9.30 QTS. (8.8 L) of engine oil with the filter replaced.

What happens if I use the wrong oil in my 2008 Audi S4?

Using oil that does not meet the SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). specification can reduce engine protection, increase wear, and potentially void warranty coverage. Always use oil that meets the OEM spec.

Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Audi S4Oil Type & Capacity

OEM spec from the factory service manual for the Avant Quattro, Automatic variant.

Quick Answer

Oil Type

$SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855).

Capacity (w/ Filter)

9.30 QTS.

8.8 L

Variant

Avant Quattro, Automatic

Note: Use only a high-quality engine oil that expressly complies with the AUDI oil quality standard specified for your vehicle's engine. Using any other oil can cause serious engine damage that will not be covered by any AUDI Limited Warranty. DO NOT mix lubricants or other additives into the engine oil. Doing so can cause engine damage. Damaged caused by these kinds of additives are not covered by any AUDI Limited Warranty. Overfilling engine oil can cause misfire DTC's to be stored in the Engine Control Module (ECM) -J220-. To prevent overfilling, add approx. 0.5 less than capacity, start engine and let it run until engine operating temperature is approx. 140Deg. F (60Deg. C), turn OFF ignition, wait approx. 3 min., check dipstick, then fill to MAX. TURBO ENGINES ONLY: After changing oil and filter, start and run engine at idle until oil pressure light goes out. DO NOT rev engine, as this could cause damage/failure of the turbocharger. Quantities are approximate. DO NOT overfill.

This vehicle's factory manual

The oil spec is above. This opens the fluids section of the 2008 Audi S4 Avant Quattro, Automatic factory book.

Open the 2008 Audi manual

Sister site: See this spec on WhatTypeOfOil.com — our quick oil type & capacity lookup for every vehicle.

Other specs:All specs

What You'll Need

Engine Oil

$SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). for Audi S4

Search Amazon →

Oil Filter

Related for Your 2008 Audi S4

Quick Actions

🏠2008 Audi S4 Hub 🛠️All Repair Guides 🤖AI Diagnosis

Frequently Asked Questions

What type of oil does a 2008 Audi S4 take?: The 2008 Audi S4 requires SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855).. The exact spec may vary slightly by engine variant — this page shows the OEM recommendation for the Avant Quattro, Automatic configuration.
How much oil does a 2008 Audi S4 need?: The 2008 Audi S4 takes 9.30 QTS. (8.8 L) of engine oil with the filter replaced.
Can I use synthetic oil in my 2008 Audi S4?: Yes — synthetic oil that meets the SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). specification is acceptable and often preferred for better protection and longer change intervals.
What happens if I use the wrong oil in my 2008 Audi S4?: Using oil that does not meet the SAE 5W-40. Petroleum or synthetic based oils. Engine oil must conform to the exact specification in VW publication VW 502 00. See TSB No. 17 09-07 (2012855). specification can reduce engine protection, increase wear, and potentially void warranty coverage. Always use oil that meets the OEM spec.